Jacuzzi J-13 - Page 40

40
M8 Mode
M8 will automacally determine when to turn the pumps on depending on the condions
and the ambient temperature. If the sensors do not detect a decrease in water temperature
from the last me it was checked, M8 will gradually increase the intervals all the way to 2
hours if the condions are very stable.
If a user removes the spa cover for example and the spa temperature starts dropping
significantly, M8 will immediately reduce the checking intervals down to 30 minutes. M8
resets the checking intervals to 30 minutes whenever the user interacts with the system
(acvates equipment, changes heang modes, changes the set temperature etc). Once the
user stops interacng with the system, M8 will resume trying to find the best possible me
and frequency at which the temperature needs to be checked.
When M8 is disabled, the system returns to its normal 30 minute intervals to check the
temperature. When M8 is re-enabled, it resumes it search for an opmized frequency at
which the temperature should be checked.
Incorporang M8 helps to minimize your energy consumpon, supports pump longevity and
helps reduce the frequency of noise associated to the pumps running.