(II)
JWL 10
7-2 Manual Tare & Preset Tare
When weighing a sample that must be held in a container, tare stores the container weight
into memory.
Manual Tare
1) Under the weighing mode, place the container on the weighing pan, wait till stable
symbol appears, and press the key TARE. The container is tared.
→
2) Place the item(s) to be weighed into the container. The weight displayed is the net weight.
3) Remove all items from the weighing pan; the screen displays the tare value.
4) To clear tare with an empty pan, Press down key TARE or key ZERO/ESC.
Preset Tare
1) Long press key TARE for 3 seconds. The scale is now in Digital inputting mode with the
left-most digit blinking.
2) Press /MR or TARE/ to move leftwards or rightwards. Press+/PRINT/HI or
HOLD/LO/- to change the value. Press M+/SAVE to save and return to weighing
mode.
3) Put the load on the container, the scale will automatically deduct the value of the
container from the total value.
NOTE: Press Key G/N to display gross and net weight by turns.
4) Clear the load on the container, and press TARE/ or ZERO/ESC to cancel the
pre-tare.
7-3 Check Weighing
Lower limit setting
1. Begin by pressing down key HOLD/LO/-. The scale is now in digital inputting mode with
the right-most digit blinking.
2. To set the value of lower limit, press key /MR to shift leftwards, key TARE/ to shift
rightwards, key +/PRINT/HI to increase setting values and key HOLD/LO/- to
decrease setting value. Key M-/SET to enable or disable the weighing checking
To Next Page
Loading...
Need help?
General
