(II)
JWL 5
4-3 Power supply
Please verify the local AC power source and switch the two-stage switch to the proper place
before plugging into the power outlet.
Alternative power supply
1) AC 110V/220V (AC±10%)
2) (6V/4A) Internal Rechargeable Battery
Power Consumption
About 300 mW without backlight
About 380 mW with backlight
Low Battery Warning
When appears in the upper left corner of the weight window, the battery requires
recharging. The charge lamp turns green from red when the recharging is completed (which
takes about 8 hours).Disconnect the scale from power supply when it is fully charged.
5 Function Setting and Description of Parameter Values
5-1 Function Setting
1. Press and hold M-/SETwhile powering on or long press M-/SETunder normal weighing
mode to enter function setting. The window displays “check”. Setting item “P00” displays
momentarily at the left bottom
2. Press /MR or TARE/ to shift between the functions
3. Press M-/SET to enter the parameter setting.
4. Press /MR or TARE/ to shift between the function parameters
5. Press M+/SAVE to save and return.
6. Press ZERO/ESC to exit without saving.
1. Memory recall
2. Select the former parameter in the same level
3. Select the former record when checking the accumulation record
4. Shift keys leftwards
1. During setting value, add 1 to the current value
2. Set the upper limit of the check weighing
3. Print
1. During setting value, deduct 1 to the current value
2. Set the lower limit of the check weighing
3. Hold function
To Next Page
Loading...
Need help?
General
