(II)
JWL 12
5. Remove the samples and put the load on, the scale calculates the amount of the load.
6. To go back to the normal weighing mode, remove the load and press key UNIT to select
the proper weighing unit.
Note:
1. The larger the sample size, the more accurate unit weight.
2. Symbol “ ” points at “UW” when calculated unit weight is lower than 4 / 5 of scale division.
7-5 Accumulation, Accumulation Display and Accumulation clear
Accumulation
Under the weighing mode, put the item on the weighing pan. Press key M+/SAVE at the
appearance of “ ”. “ ” is displayed momentarily before the display reverts to the
weight of the item.
Remove the item and the display goes back to zero before the next accumulation can register.
（The maximum is 99 pieces, display the latest 10 accumulation events in details ）
Accumulation Display
Press key M-/SETto display the accumulation data
/MR or TARE/ to check the total accumulation and each accumulation event in detail.
The number of weighments is indicated by Auxiliary display at the left bottom.
XX=Total accumulation； XX=certain accumulation
Accumulation Clear
To clear accumulation data (total accumulation data or one of the accumulation events), press
key M-/SET while the data is displayed. To exit and return to normal weighing mode press
key ZERO/ESC.
7-6 Printer initialization by the indicator operation
1. Press M-/SETwhile powering on to enter parameter setting. Use key /MR or TARE/
to shift to P09
2. Press M-/SETto enter the external device setting. Press /MR or TARE/ to choose
the printer model
3. Shift to certain printer model. Press M-/SETand the window will show “UNSUP” or “INIT?”
“UNSUP” means the printer is no need for initialization. Press ZERO/ESC to return.
To Next Page
Loading...
Need help?
General
