(II)
JWL 13
“init?” means the printer is should be initialized. Press MR/SAVE to initialize the printer.
When the initialization is finished, the window will show “ok”. And then displays the printer
model. Press ZERO/ESC to return.
7-7 Input commands
Connect the indicator and computer. Run serial port debugging program on the computer.
Input the capital number “Z”, “T”, “R” ,“C”,“P”in the sending area, and the indicator can
conduct the corresponding actions.
Z=zero
T=tare
C=cancel tare
R/P=reading / print
8. Serial Interface
If external interface is needed, please select the proper three-in-one board first, which
integrates RTC (time display), RS-232 and relay (weight checking) functional module onto
one circuit board. Only after this board is adopted, the three functions can be realized.
8-1 RS-232 Diagram
Single Option
1) RS232+RTC+Relay+ (SH-24，BP545D , Godex and ZEBRA) printer
2) RS232+RTC+Relay+ LED Light Tower (Applicable to the quality control of the factory
product quantity or weight and that of the total production line.)
3) RS232+RTC+Relay+Computer
To Next Page
Loading...
Need help?
General
