(II)
JWL 8
stable：Stable print（weight is equal or more than 20d）
key：Manual print by pressing key PRINT
13. P12: Print format
See the appendix (more than 100 formats. The appendix just shows two formats.)
14. P13: Filtering setting
Set the filtering level in which the stable indication turns on. The higher the setting, the
slower stabilization time
Options: 1，2，3，4
15. P14： Tare/Zero condition
stable ： Only after the stable indication appears, Tare/Zero function acts after pressing
down key TARE or ZERO
always： Tare/Zero function acts by pressing down key TARE or ZERO even if it is not
stable
auto: Press down key TARE or ZERO even if it is not stable, but Tare/Zero function
acts after stable
16. P15： RTC set
on: Enable RTC function
off: Disable RTC function
RTC setting:
When the window shows “on”, press M-/SETto enter RTC setting and the window shows
the year. Press /MR or TARE/ to choose date and time. Press M-/SETto enter
setting. Press /MR or TARE/ to shift key leftward or rightward; Press +/PRINT/HI
or HOLD/LO/- to change the value. Press M+/SAVE to return.
17. P 16: Zero-Offset function.
ON display the previous weight when powering on again
OFF not display the previous weight when powering on again
18. P17： Initialization
Press M-/SET then press M+/SAVE to initialization and the window display RESET.
6.Calibration
Note: Before calibration, please set the unit first. The unit used in calibration is the one that
To Next Page
Loading...
Need help?
General
