EasyManua.ls Logo

Jandy APURE35 - Cell Cleaning Procedure

Jandy APURE35
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 26
6.3 Cleaning the Cell
Figure 27. Invert the CellFigure 25. Undo Locking Ring Figure 26. Remove the Cell
WARNING
Whencleaningthecell,wearprotectiveeyeglassesandgloves.
Whenmixingacidwithwater,ALWAYS ADD ACID TO WATER. NEVER ADD WATER TO ACID.
The power pack has an automatic cell cleaning feature (polarity reversing) that removes scale deposits from the cell
(seeSection5.6).
Scalewillforminexcessivelyhardwaterorfrompoolwaterthatisoutofbalanceandinascalingcondition.
FollowingtheinstallationoftheJandy®AquaPure®Eichlorinegeneratingdevice,checkthecellonceamonthfor
signs of scale.
If the cell has a tendency to scale, it is recommended that every month the cell be removed and inspected for scale
formationand/ordebris.Someltersallowdebristopassthroughtothecellwhichcouldlodgebetweentheplates
in the cell. A small amount of scale formation is normal. If by looking through the cell it is observed that there is
excessivescaleformationbetweentheplatesordebrisispresent,thecellmustbecleanedasfollows:
1. Ensure that all power to the power pack and the controller is disconnected/turned off at the circuit breaker.
2.
Shut off any necessary valves to prevent any water loss.
3. Removetheterminalcapandcellleads.
4. Undothelockingring.Ifrequired,usethelockingringtoolprovided(seeFigure25).
5. Removethecell(seeFigure26).
6. Retthecaponthecellandinvert(seeFigure27).
7. Withprotectiveglassesandgloveson,addone(1)partacidtoten(10)partswaterandmix.
8. Fillthecelltothetopoftheelectrodeplateswiththeacidsolution.Leavesolutionincellnolongerthan30min.
9. After the cell has been cleaned, you can dispose of the solution by pouring it into the pool water or dispose of
according to local regulations.
10. ReattachthecellasdescribedinSection3.3,steps13and14.
Disconnectpowertothesystematthemaincircuitbreakerbeforeperformingthisproceduretoavoidriskof
electricshockwhichcanresultinpropertydamage,severeinjuryordeath.
WARNING
Locking Ring
Tool

Table of Contents

Related product manuals