Page 5
ENGLISH
Jandy
®
Pro Series JE Heat Pumps
|
Installation and Operation Manual
Flex conduit is recommended for connecting
the electrical supply wires to the heat pump so
that the front panel may be removed easily for
servicing.
must
Plastic 2” PVC (Unions included)
Maximum
Optimum
Minimum
70 gpm (265 lpm)
60 gpm (230 lpm)
20 gpm (76 lpm)
75 psi
Voltage Requirements
1-Phase
3-Phase
230 VAC 60Hz
230 VAC 60Hz
(Model dependent)
600 PSI
Indoor installations require special
considerations for condensate drainage and
venting the cold air produced by the heat
pump. Contact the Zodiac technical support
department at (800) 822-7933.
When pool equipment is located below the pool
surface, a leak from any component can cause
large scale water loss or ooding. Zodiac cannot
be responsible for such water loss or ooding or
resulting damage.
To Next Page
Loading...
