Jandy EE-Ti User Manual

H0335800 RevD
Installation and
Op er a tion Man u al
Installation and Operation Data
WARNING
FOR YOUR SAFETY - This product must be installed by a licensed HVAC technician certifi ed
in heat pump repair and maintenance by the jurisdiction in which the product will be installed
where such state or local requirements exists. The technician must possess and comply with all
certifi cations and regulations regarding the purchasing, handling, transportation and reclamation of
R410A refrigerant. In the event no such state or local requirement exists, the installer or maintainer
must be a professional with suffi cient experience in pool equipment installation and maintenance
so that all of the instructions in this manual can be followed exactly. Before installing this product,
read and follow all warning notices and instructions that accompany this product. Failure to
follow warning notices and instructions may result in property damage, personal injury, or death.
Improper installation and/or operation can create an electrical hazard which can cause serious
injury, property damage, or death. Improper installation and/or operation will void the warranty.
Jandy
®
Heat Pumps
Model EE-Ti
English
Français
Español

Jandy EE-Ti Specifications

General

Brand	Jandy
Model	EE-Ti
Category	Heat Pump
Language	English

Summary

General Information

Consumer Information and Safety

Details safety guidelines for heat pump use, including spa/hot tub rules and energy saving tips.

Spa/Hot Tub Safety Rules

Outlines critical safety rules for spa and hot tub usage, emphasizing temperature limits and responsible use.

Codes and Standards

Installation Instructions

Location Requirements

Specifies criteria for selecting an appropriate installation site, considering clearances and environmental factors.

Clearances

Installation of Anchor Clamps

Electrical Connections

General Information

Main Power

Provides a step-by-step procedure for connecting the heat pump to the main electrical power source.

Bonding

Explains the requirement for bonding the heat pump to the pool's grounding grid with a copper wire.

Pump Connection (Maintain Temp Feature)

Optional Remote Controls

Describes wiring and configuration for various optional remote control systems.

Connection to a Remote Pool-Off-Spa Selector (3-Wire Connection)

Instructions for wiring and configuring a 3-wire remote selector for pool/spa control.

Two-Wire Connection to an AquaLink® RS or TSTAT

Details wiring and setup for connecting to AquaLink RS or TSTAT systems via a two-wire connection.

Configure the Control Panel

Four-Wire Connection to AquaLink® RS 485 Communication

Instructions for connecting the heat pump to an AquaLink RS system using 4-wire communication.

Connection to a Secondary User Interface

Guides on connecting an additional user interface for remote control of the heat pump.

Operation

Initial Start-up Precautions

Essential steps before initial heat pump start-up, including water circulation and filter cleaning.

Operating the Controller

Pool Mode - (Normal Heat)

Instructions for operating the heat pump in pool mode for normal heating with temperature setpoint adjustment.

Pool Mode - (Optional Maintain Heat)

Details how to use the Maintain Heat feature for continuous pool temperature monitoring and heating.

Spa Mode - (Normal Heat)

Instructions for operating the heat pump in spa mode for normal heating with temperature setpoint adjustment.

Spa Mode - (Optional Maintain Heat)

Operating Features of Hybrid Units with Optional Chiller

Pool Mode - (Normal Chill)

Pool Mode - (Optional Maintain Chill)

Spa Mode - (Optional Maintain Chill)

User Setup Options

Water Pressure Switch Adjustment

Guidance on adjusting the water pressure switch for proper heat pump operation and shutdown.

General Maintenance

Water Chemistry

Winterizing

Provides steps to properly drain and protect the heat pump in freezing temperature areas.

Spring Start-Up

Step-by-step instructions for safely starting up the heat pump system after winterization.

Professional Inspection

Troubleshooting

Troubleshooting Guide

A table listing common heat pump symptoms and their corresponding corrective actions.

Diagnostics

Lists diagnostic conditions displayed on the LCD screen and their descriptions for fault identification.