Janome 4300QDC - LCD Display; Touch Panel

11
LCD Display
NOTE:
Magnetic or electrostatic interference may cause the
D display to icker.
Do not use the machine near appliances that generate
a magnetic eld or an electrostatic eld such as
microwave ovens.
The LCD display shows following information when the
machine is turned on.
q Stitch pattern
w Mode
e Stitch pattern number
r Identication letter of the recommended foot
t Stitch width
y Stitch length
re
w
q t y
q w e r
y
u
i
t
q Mode key
When the power switch is turned on, the direct pattern
selection (mode 1) is set automatically.
Press the mode key to change the mode. Refer to
page 24.
w Clear key
Press the clear keyto cancel the input and select the
rst stitch pattern of the selected mode.
• In pattern combination:
Press the clear key to clear the registered stitch
pattern.
Press and hold the clear key until the buzzer beeps to
clear whole pattern combination. Refer to page 70.
e Mirror image key
ress the mirror image key to ip the selected stitch
pattern vertically. Refer to page 63.
r Memory key
Press the memory key to register the selected pattern.
Refer to page 61.
t Number keys (Refer to page 24)
• Direct pattern selection
You can select the stitch patterns from 01 to 10
directly in mode 1 (direct pattern selection mode).
• Numeric pattern selection
Enter a 2-digit pattern number to select the desired
stitch pattern in modes 2 to 5.
y Stitch width adjusting key
Press “+” or “–” to change the stitch width or needle
drop position, depending on the selected stitch
pattern. Refer topages 29, 32 and 39.
u Stitch length adjusting key
Press “+” or “–” to change the stitch length of the
selected pattern. You can also adjust the buttonhole
density, the evenness of darning, and the size of
eyelet with this key. Refer to pages 29, 32 and 39.
i Cursor key
Press “ ” or “ ” to move the cursor to check or edit
the pattern combination. Refer to pages 69 and 70.
Touch Panel