Janome 4300QDC - Knit Stitch; Double Overedge Stitch; Overlock Stitch

34
lace your fabric to allow a 5 (1.5 cm) seam. Trim
excess close to the stitching. Be careful not to cut the
stitches.
Knit Stitch
q Stitch pattern: MODE 2: 13
w Thread tension dial: 3 to 6
e Presser foot: Zigzag foot A
Double Overedge Stitch
q Stitch pattern: MODE 2: 14
w Thread tension dial: 3 to 7
e Presser foot: Overedge foot C
4
weq
4
weq
q
This stitch is excellent for sewing fabrics that tend to fray
extensively such as linens and gabardines.
Two rows of zigzag stitches are simultaneously sewn
over the edge to insure that your seams will not ravel.
Sew while guiding the fabric edges along the guide on
the foot.
q Guide
NOTE:
The stitch width cannot be adjusted to less than 4.5 to
prevent the needle from hitting the wires on the foot.
Overlock Stitch
q Stitch pattern: MODE 2: 15
w Thread tension dial: 6 to 8
e Presser foot: Overcast foot M
weq
q
This stitch nishes the edges of fabric in a way similar
to a commercial overlocking machine for a professional
look.
Place the fabric edge next to the guide of the foot and
sew.
q Guide
NOTE:
The identication letter for the recommended foot will
not be displayed on the LCD when the overlock stitch
pattern is selected. To sew the overlock stitch pattern,
attach the overcast foot M.