Janome 4300QDC - Altering the Buttonhole Width; Altering the Buttonhole Density

39
Altering the buttonhole width
Press the “+” sign on the stitch width adjusting key to
increase the buttonhole width.
Press the “–” sign on the stitch width adjusting key to
decrease the buttonhole width.
q Stitch width adjusting key
NOTE:
The buttonhole width can be adjusted from 2.5 to 7.0.
n The buttonhole is sewn in the sequence as shown.
hen the buttonhole is nished, the machine will stop
automatically with the needle in the up position.
Double layer buttonhole
To make a sturdy buttonhole, sew another layer of
buttonhole stitches over the previous stitches.
fter the buttonhole is nished, do not raise the foot or
buttonhole lever, simply start the machine again.
n
,
m
!3
!4
, Remove the fabric and place a pin just below the
bartack to prevent accidentally cutting the stitches.
Cut the opening with the seam ripper.
!3 Pin
!4 Seam ripper
m hen buttonhole sewing is nished, push the
buttonhole lever upward as far as it will go.
y Buttonhole lever
y
Altering the buttonhole density
Press the “+” sign on the stitch length adjusting key to
decrease the buttonhole density.
Press the “–” sign on the stitch length adjusting key to
increase the buttonhole density.
q Stitch length adjusting key
NOTE:
The buttonhole density can be adjusted from 0.2 to 0.8.
NOTE:
If the fabric is not feeding smoothly when sewing
a double layer buttonhole, increase the buttonhole
density.
q
q
+–
+–