Janome 4300QDC - Inserting the Bobbin

20
b Attach the hook cover plate. Check the threading by
referring to the diagram y shown on the hook cover
plate.
y Threading diagram
Inserting the bobbin
CAUTION:
Turn OFF the power switch before inserting the bobbin
and threading the bobbin holder.
z Place a bobbin in the bobbin holder with the thread
running off counterclockwise as shown on the hook
cover plate.
q End of thread
w Bobbin holder
e Hook cover plate
e
w
q
z
x
c
v
b
x uide the thread into the rst notch on the frontside
of the bobbin holder.
r Notch
c Draw the thread to the left, sliding it between the
tension spring blades.
v Continue to draw the thread lightly until the thread
slips into the second notch t. ull out about (15
cm) of thread.
t Notch
r
t
y