Janome 4300QDC - Threading the Machine

21
CAUTION:
Turn OFF the power switch before threading the
machine.
z
x
c
v b
z Turn the power switch off.
Draw the end of the thread around the upper thread
guide.
Threading the Machine
x While holding the thread near the spool w, draw
the end of the thread down around the check spring
holder e.
w Spool
e Check spring holder
c Firmly draw the thread up from right to left over the
take-up lever, and down into the eye of take-up lever.
r Eye of take-up lever
v Pass the thread through the lower thread guide. Slide
the thread behind the needle bar thread guide on the
left.
t Lower thread guide
y Needle bar thread guide
b Use the needle threader to thread the needle (see
page 22).
Raise the presser foot. Press the
needle up/down button q to raise
the thread take-up lever to its
highest position.
q Needle up/down button
e
r
t
y
q
w
z
c
v
b
x
w