46
Adjusting the shape of an eyelet
Correct the shape of the eyelet as follows:
“L3” is the default setting value.
If the eyelet gap overlaps, press the “+” sign on the stitch
length adjusting key to make the darn even.
If the eyelet gap opens, press the “–” sign on the stitch
length adjusting key to make the darn even.
q Stitch length adjusting key
NOTE:
The shape can be adjusted within L1 to L5.
Eyelet
q Stitch pattern: MODE 2: 36
w Thread tension dial: 1 to 4
e Presser foot: Satin stitch foot F
The eyelet is used for belt holes etc.
Starting to sew
Lower the needle at the starting point and lower the
presser foot. Start the machine.
The machine will stop automatically when completed.
q Starting point
Open the eyelet with an awl, eyelet punch or pointed
scissors (an awl, eyelet punch or pointed scissors are not
provided with the machine).
q
To Next Page
Loading...
