Janome MC6600P - Setting for Dual Feed Sewing

13
1
2
3
4
5
2
1
Loosen the thumb screw and remove the foot holder.
2 Thumb screw
3 Foot holder
Attach the Dual feed foot to the pressure bar, and tighten
thumbscrew lightly. Lower the presser foot lifter and
tighten the thumbscrew securely.
4 Dual feed foot
5 Pressure bar
To attach the Dual feed foot:
To engage the dual feed device
When you use the Dual feed, attach the Dual feed as
follows.
(See page 27)
Setting for Dual Feed Sewing
Raise the needle and presser foot.
1 Presser foot lifter
Raise the presser foot lifter to its extra lift position.
1 Extra lift position
Lower the Dual feed device slowly and swing forward
to the under side of the Dual feed foot untill they
engage.
2 Dual feed device