Janome MC6700P - Changing the printed circuit board F and slide volume; Printed circuit board F; Slide volume

9
Changing the printed circuit board F and slide volume
Printed circuit board F
To remove:
1. Remove the front cover.
2. Disconnect the connector for printed circuit board F
and slide volume connector.
3. Remove the setscrews A (3 pcs.) and reomve the
printed circuit board F.
To attach:
4. Follow the steps of removal procedure in reverse.
Printed circuit board F
Snap ring
CS-3
Slide volume
To remove:
1. Remove the front cover.
2. Disconnect the slide volume connector from the
printed circuit board F.
3. Remove the snap rings CS-3 (2 pcs.) and remove the
slide volume.
To attach:
4. Follow the steps of removal procedure in reverse.
* Insert the projection of slide volume into the convex
of speed control slider and fix it with the snap rings
(indicated by an arrow).
Slide volume
Setscrew A
Snap ring CS-3
Connector for printed
circuit board F
Slide volume
connector
Slide volume
connector