Janome MC6700P - Drop feed micro switch

42
Drop feed micro switch
To change:
To remove:
1. Remove the front cover and base.
2. Disconnect the connector for drop feed micro switch
from the printed circuit board A.
3. Remove the setscrew A and drop feed micro switch.
To attach:
Follow the steps of removal procedure in reverse.
* After attaching the drop feed micro switch, check
following the steps below.
Auto-lock key
Needle up/down key
ON
(Factory setting mode)
(Numeral key) (Sensor adjusting mode)
To adjust and check:
1. Turn the power switch on while pressing the auto-
lock key and needle up/doun key to enter the factory
setting mode.
2. Press the numeral key “4” to select the sensor
adjusting mode.
3. Check if the indication of “FeedDog” is “L” when the
feed dog drop lever is in the right (feed dog raised).
Check if the indication of “FeedDog” is “H when the
feed dog drop lever is in the right (feed dog lowered).
If the indication is not correct, adjust the position of the
drop feed micro switch.
Setscrew A
Drop feed micro switch
Feed dog drop lever
(View from the belt cover side)
Setscrew B
Feed dog drop lever
To the right
(feed dog raised)