Janome MC6700P - Needle threader hook position

25
Needle threader hook position
The threader hook comes out through the needle eye from behind when the needle threader
lever is lowered.
1. Push down the threader lever and hold it just before
the threader hook enters the needle eye.
2. If the threader hook is not aligned vertically with the
needle eye, loosen the setscrew A. Adjust the stopper
position so that the hook enters into the needle eye.
3. Tighten the setscrew A.
4. If the threader hook is not aligned horizontally with the
needle eye, loosen the setscrew B. Adjust the stopper
position so that the hook enters into the needle eye.
5. Tighten the setscrew B.
Setscrew A
Setscrew B
Stopper
Hook
Hook holder