35
To replace driving motor
To remove:
1. Remove the top cover, face plate, front cover and
belt cover.
2. Remove the motor belt.
3. Disconnect the motor connector from the printed
circuit board A.
4. Remove the setscrews (2 pcs.) and replace the
motor.
To attach:
5. Fix the motor by tightening the setscrew (2 pcs.)
lightly.
6. Adjust the belt tension and tighten the setscrew (2
pcs.) securely.
7. Connect the motor connector to the printed circuit
board A.
Correct motor belt tension:
Adjust the motor belt deflection to about 5 mm by
pressing the middle of the motor belt with your finger
with approximately 200 grams of pressure.
Setscrew
Pressure: 200 gf
Deflection: 5 mm
Setscrew Setscrew
To Next Page
Loading...
