12
Needle drop position
1. Remove the face plate. Select straight stitch #1 ( )
in mode 1 and check the needle drop position. Select
zigzag stitch #5 ( )in mode 1 and check the needle
drop position.
2. To adjust the needle drop position, loosen the
setscrew and turn the eccentric pin.
(The direction of eccentricity should be in the upper
part.)
* Remove the arm thread guide (unit) (see page 6).
3. Tighten the setscrew.
4. Attach the face plate.
When the straight stitch is selected, the needle should be positioned in the center of the
needle plate hole.
When the zigzag stitch is selected with the maximum stitch width of 9.0, the clearance
between the side of the needle and needle hole should be 0.2 mm or more.
Needle hole
0.2 mm or more0.2 mm or more
A = B
Setscrew
Eccentricity is to be
adjusted in the upper
part.
Eccentricity
Eccentric pin
To Next Page
Loading...
Need help?
General
