30
Upper feed dog (3)
To check :
1. Attach the dual feed foot and needle #14.
2. Turn the power switch on and select the straight stitch
#1 ( ). Set the zigzag width at “0”.
3 Set the upper feed adjusting dial at “0”.
4. Lower the feed dog and press the needle up/down
key twice to raise the needle. Turn the power switch
off.
* To initialize the feed dog position, be sure to press
the needle up/down key twice to raise the needle.
5. Lower the presser foot lifter.
6. Raise the toe of the dual feed foot and leave it as it is.
7. Turn the handwheel toward you to lower the needle
until the needle tip comes 1 mm or less above the
needle plate. The toe of the foot lands on the needle
plate and there is no gap to allow the foot flapping.
If not, adjust it as follows.
The needle tip should be 0 to 1 mm above the surface of the needle plate when the toe of
the dual feed foot touch the needle plate.
Surface of
the needle
plate
Upper feed adjusting dial
0 to 1 mm
away from the
needle plate
No clearance
Clearance
To Next Page
Loading...
