20
Inserting the Bobbin
q
w
e
r
z Place the bobbin in the bobbin holder with the thread
running off counterclockwise.
x Guide the thread into the front notch on the bobbin
holder.
q Front notch
c Draw the thread to the left, sliding it between the
tension spring blades.
w Tension spring blades
v Continue to draw the thread lightly until the thread
slips into the side notch.
e Side notch
z
x
c
v
b b Pull out about 10 cm (4˝) of thread to the rear.
Reattach the hook cover plate.
r Hook cover plate
NOTE:
The threading chart is shown on the hook cover plate
for your reference.
CAUTION:
Always make sure to press the lockout key to lockout
the machine or turn the power switch off before
threading the machine.
Janome 8200 Sewing Machine Instruction Manual
MC8200 Owners Manual/ User Guide
To Next Page
Loading...
