Janome Memory Craft 8200QC - Programming Pattern Combinations; Pattern Combination Basics

JanomeFlyer.com
65
Stippling
Machine settings
q Pattern: MODE 3: 31
w Thread tension: AUTO
e Presser foot: Satin stitch foot F or
Open-toe satin stitch foot F2
r Foot pressure: 5
* Stitch patterns (mode 3) can also be used.
q
e
w
r
A pre-programmed stippling stitch is a fast and easy
method to quilt small areas.
Place a quilt layer and sew.
Free Motion Quilting (1)
Machine settings
q Pattern: MODE 1: 4S
w Thread tension: AUTO
e Presser foot: Convertible free motion quilting
foot QB-S
r Foot pressure: 5
t Feed dog: Lowered
q
e
w
r
Attaching the convertible free motion quilting foot
Attach the needle plate for straight stitch (refer to page 16).
Loosen the setscrew and remove the foot holder.
Attach the convertible free motion quilting foot to the
presser bar and tighten the setscrew firmly with the
screwdriver.
Place the fabric under the foot.
Adjust the height of the foot by turning the round nut until
bottom of the foot barely touches top of the fabric.
q Setscrew
w Presser bar
e Round nut
q
w
e
t
q
e
w
r
Clasp Stitches
Machine settings
q Pattern: MODE 3: 34
w Thread tension: AUTO
e Presser foot: Satin stitch foot F
r Foot pressure: 5
Youcanclosequiltlayersandusingtheclaspstitch.
Select stitch pattern 34 (mode 3). Press the memory key.
Select locking stitch (pattern 93 (mode 3)).
Start sewing.
The machine sews clasp stitch and locking stitch then
stops automatically.
Janome 8200 Sewing Machine Instruction Manual
www.janomeflyer.com
MC8200 Owners Manual/ User Guide