30
MO200
5200QDC
REPLACING THE ZIGZAG WIDTH MOTOR
TO REMOVE:
1. Remove the board "A" (see page 24).
2. Remove the two zigzag rod setscrews (A). Disconnect the connector from the board "A".
3. Remove the two setscrews (B) and remove the zigzag width motor.
TO INSTALL:
4. To install the zigzag width motor, follow the above procedure in reverse.
NOTE
1. The setscrew of zigzag rod should be tightened to 5~7 kg of torque.
2. Check to ensure that the upper shaft sensor mounted on the zigzag width motor does not interfere
with the upper shaft shield plate.
3. Adjust the needle drop position (see page 8).
REPLACING THE ZIGZAG WIDTH MOTOR
Setscrew (B)
Setscrew (B)
Zigzag rod setscrew (A)
Setscrew (B)
Setscrew (B)
Zigzag width motor
To Next Page
Loading...
