Janome MO200 - Sewing Machine Service Access - Front Cover; Front Cover Removal and Installation

5
MO200
5200QDC
SERVICE ACCESS (4)
FRONT COVER
TO REMOVE:
1. Remove the top cover and belt cover (see pages 2 and 6).
2. Loosen the setscrew (A), (B), (C), (D) and (E), remove the setscrew (F).
(Remove setscrews for the lump fixing plate when the setscrew (A) is hard to access.)
3. Disconnect the connector and flexible cable from the board "A", then remove the front cover (disengage
part G).
TO INSTALL:
2. Follow the above procedure in reverse.
Setscrew (A)
Setscrew (B)
Setscrew (C)
Setscrew (D)
Setscrew (E)
Setscrew (F)
Part G
Flexible cable
Printed circuit board "F"
connector