Janson Controls FC100-2S-0.7G User Manual

54
P204 Dc braking current in start
SettingRange:0~150Unit:1
Factory Setting: 100
Dc braking in start is application for fan in stop mode and moving load. Because
before inverter starts, motor is in free mnriing modeand the rotation direction is
unknown. It is easy to cause over current protection in start. Therefore, before
start, you shall use DC injection brake to stop the motor in advance.
Dc braking current in start is the ratio of rated current of inverter, adjusting P204
can have different braking torques. While setting value of parameter, you can
adjust it from low to high until a sufficient braking torque is reached according to
the actual load.
Dc braking time is the period DC injection brake lasts. When it is 0, DC injection
brake is invalid.
P205 Dc braking time in start
SettingRange:0~250Unit:1
Factory Setting: 0
P206 Dc braking current in stop
SettingRange:0~150Unit:1
Factory Setting: 100
P207 Dc braking time in stop
SettingRange:0~250Unit:1
Factory Setting: 0
Dc braking in stop is application for load which has requirement on braking.
Dc braking current in stop is the ratio of rated current of inverter. Adjusting this
parameter can have different braking torques.
Dc braking time in stop is the period DC injection brake mode lasts. When it is 0,
DC injection brake is invalid.
Refer to the explanations of P203, P204 and P205 for relevant details.
6
Chapter 6 Description of parameter setting
FC100 Series User Manaul

Janson Controls FC100-2S-0.7G Specifications

General

Brand	Janson Controls
Model	FC100-2S-0.7G
Category	Controller
Language	English