Janson Controls FC100-2S-0.7G User Manual

57
P218 Self inductance of rotor
SettingRange:0~1.0Unit:0.1
Factory Setting: 1
P219 Mutual inductance of rotor
SettingRange:0~1.0Unit:0.1
Factory Setting: 0.2
The above parameters are parameters of motor.
P215 Rated frequency of motor
Please set rated frequency of motor according to motor nameplate.
P216 Resistance of stator
P217 Resistance of rotor
P218 Self inductance of rotor
P219 Mutual inductance of rotor
Set the above parameters according to the actual condition of motor.
The above parameters are parameters of motor.
P215 Rated frequency of motor
Please set rated frequency of motor according to motor nameplate.
P216 Resistance of stator
P217 Resistance of rotor
P218 Self inductance of rotor
P219 Mutual inductance of rotor
Set the above parameters according to the actual condition of motor.
Group 3: Input and Output Function Parameters
P300 AVI minimum voltage input
SettingRange:0~AVI Unit:0.1maximum voltage
Factory Setting: 0
P301 AVI maximum voltage input
Setting Range: AVI maximum voltage~0 Unit:0.1
Factory Setting: 10
P302 AVI input filter time
Setting Range: 0~25.0 Unit:1
P300 AVI minimum voltage input
AVI minimum voltage input value is related to frequency of lowest analogue
input. Voltage command below this value is deemed as invalid command.
P301 AVI ma imum voltage inputx
AVI maximum voltage input value is related to frequency of highest analogue
input. For voltage higher than this value, the machine willstill operate at this
value.
The value of P300 and that of P301 decide the range of input voltage.
Factory Setting: 1.0
6
Chapter 6 Description of parameter setting
FC100 Series User Manaul

Janson Controls FC100-2S-0.7G Specifications

General

Brand	Janson Controls
Model	FC100-2S-0.7G
Category	Controller
Language	English