Janson Controls FC100-2S-0.7G User Manual

98
Factory Setting:2.0
Current display filter time
P806
Setting Range:0~100 Unit:1
This parameter setting is relevant to the stabilization of current display, and
shall not be modified in general. If the setting is too small, current display will
fluctuate.
The above parameters are factory default setting, normally shall not be
adjusted, otherwise it may cause abnormal operation.
0-10V analogue output low end calibration coefficient
P807
Setting Range:0~9999 Unit:1
0-10V analog output high end calibration coefficient
P808
Setting Range:0~9999 Unit:1
0-20mA analogue output low end calibration coefficient
P809
Setting Range:0~9999 Unit:1
0-20mA analog output high end calibration coefficient
P810
Setting Range:0~9999 Unit:1
6
Chapter 6 Description of parameter setting
FC100 Series User Manaul

Janson Controls FC100-2S-0.7G Specifications

General

Brand	Janson Controls
Model	FC100-2S-0.7G
Category	Controller
Language	English