EasyManua.ls Logo

Jayco Eagle TT 2020 - Page 133

Jayco Eagle TT 2020
201 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...

131
1. Turn power to the water heater OFF (both electric and LP gas switches.
2. Level the recreation vehicle and drain the fresh water plumbing system. See Draining
the Fresh Water System.
3. Replace the water lter cartridge (if so equipped) with the plastic bypass hose.
If RV has a canister water lter, turn o water to the lter (valves should be on either
side of the lter). Remove the lid, remove the lter, replace the lid. Turn on the water
valves.
4. Water heater should now be empty after per-
forming Step 2. The water heater bypass
valves should be set to . Refer to
2-Valve Water Heater Bypass section.
5. Make sure the “fresh water tank drain” and
“low point drains” are all closed. Low point
drains are typically located inside the base-
ment access cover for hot and cold water
lines.
6. Open the basement access cover to locate the
BLACK and WHITE water valves and set
them to positions
(as shown).
7. Place the end of the clear plastic hose into a container of RV antifreeze.
8. Turn the water pump switch ON. Antifreeze will siphon into the water lines when a
xture is opened. To aid in siphoning, place the container of antifreeze on a at surface
2 feet above the ground. All drains should be closed to create a siphon.
9. Open each hot water faucet one at a time, including outside shower and outside kitchen
(if so equipped) until RV antifreeze begins to ow continuously then close the water
faucet. Repeat for all hot water faucets.
10. Repeat Step 8 with the cold water faucets including outside shower and outside kitchen
(if equipped).
11. Hold open the lever on the toilet until antifreeze runs into the bowl.
12. Appliances should be winterized to prevent damage. Refrigerator, dishwasher, clothes
washer should be winterized. Refer to the appliance owners manual for instructions
or call Customer Service.

1. Ensure all tanks are empty.
2. Pour RV antifreeze into the empty black water tank (through the toilet bowl).
(Be sure to have a container available for capturing system uid.)
3. Turn the macerator pump ON.
4. Run the pump until antifreeze begins to discharge from the dump connector on the end
of the exible hose.
5. Turn the macerator pump OFF.
 Antifreeze should never enter the hot water heater or the
water lter.

Table of Contents