168
If you need to clean the condenser:
Remove the base grille.
Use a vacuum cleaner with a soft brush to clean the grille, the open areas behind
the grille and the front surface area of the condenser.
Replace the base grille when nished.
: wash with a clean sponge or soft cloth and a mild detergent in
warm water.
wash with a clean sponge or soft cloth and a mild detergent in
warm water. Do not use appliance wax, polish, bleach, or other products containing chlorine
on stainless steel. Stainless steel can be cleaned with a commercially available stainless
steel cleaner. A spray-on stainless steel cleaner works best.
For silver-accented plastic parts, wash with soap or other mild detergents. Wipe clean with
a sponge or damp cloth. Do not use scouring pads, powdered cleaners, bleach or cleaners
containing bleach as these products can scratch and weaken the paint nish.
Washer/Dryer Prep (if so equipped)
If your recreation vehicle was built with washer/dryer prep, be aware the cabinet space pro-
vided is intended for the installation of an aftermarket washer/dryer combo unit (customer
supplied) only. Please consult your dealer or the manufacturer for instal-
lation assistance.
A dryer vent opening must be cut into the sidewall of the RV if installing
a dryer. A label has been installed to assist you in placing the vent in
the correct location. The label will be located in the area where the
dryer will be installed. Instructions on how to cut the dryer vent hole
and how to install the dryer vent in the wall of the RV are included in
your warranty packet.
Gas dryers should be installed in your recreation vehicle. Dryer prep
has been designed for electric dryer operation .
Do not operate a dryer in the recreation vehicle unless the dryer is properly
vented.
To Next Page
Loading...
Need help?
General
