54
The tongue jack can also be overridden by removing the
rubber plug to the right of the touch screen in the com-
partment on top of the tongue jack. Use a ratchet wrench
and insert a 3/8” square drive extension into the square
hole located inside the plastic cover.
The rear leveling jack legs can be manually overridden as
well. There is a plastic plug located on each leg motor.
Remove the plastic plug to reveal a 5/16” hex adapter.
Use an electric drill with a 5/16” socket to manually raise or lower each rear leg.
Electric stabilizer jacks can be overridden manually also. To manually operate the stabilizer
jacks, use a drill with a 3/4” socket and put it on the 3/4” nut on the end of the stabilizer jack.
Refer to the manufacturer’s owner manual in your warranty packet for further information
regarding troubleshooting, error codes, and care and maintenance.
To Next Page
Loading...
