45
As a result of this design, backing the RV uphill may activate the surge brake system making
it dicult to continue in reverse. To aid in backing up the RV:
1. Prior to backing up a slope or through soft ground, pull the recreation vehicle forward
slightly to assure that the actuator socket is in the forward position.
2. Move the lever on the side of the actuator downward from the “towing position” along
the curved slot in the actuator frame to the “backup position.” The slot has a notch at
the bottom of its travel. Push the lever down to engage the locking notch.
3. The RV will now back up. This lever will slide into the correct position when pulling
forward.
It is extremely important to keep the master cylinder full at all times. An empty cylinder
invites moisture.
If your RV is equipped with disc brakes, see the manufacturer’s owner’s manual for detailed
safety and maintenance information.
Towing Behind Your RV
If you do not have a , towing items
behind your Jayco RV, or overloading the rear, will void the warranty and may
result in: damage to the RV or add-on items, towing diculties, property dam-
age and/or personal injury.
A hitch equipped for trailer towing will have tabs to hang
the safety chains and there will be a bracket for the trailer wiring plug.
There should also be a label on the hitch stating maximum towing
capacity.
To Next Page
Loading...
Need help?
General
