JBL KX100 - 4.2 Factory Reset

26
KX100
Section 4
Appendix
4.2 Factory Reset
The Factory Reset will delete all User Presets and set all parameters back to the factory
default state. To perform the Factory Reset procedure, please follow these steps:
1 . Turn off the KX100.
2 . While pressing and holding the Store button, apply power to the KX100.
3 . Keep holding the Store button until the following message appears in the display:
‘FACTORY RESET
Select to Exit’
4 . At this point you can abort the reset procedure by pressing any button. If you would
like to proceed with the Factory Reset, turn the Adjust/Select knob until the display
reads the following:
‘FACTORY RESET
Select to Reset’
5 . Now press the Adjust/Select knob.
6 . You will receive a confirmation prompt on the display reading:
‘Press Select to
Reset Settings’
7 . Press the Adjust/Select knob to initiate the reset procedure.