Steering
9803/7130 Issue 1
Steer Unit Operation 1 - Neutral
Flow from the priority valve enters the steering unit
through the bottom right hand port past the non-
return valve 43C. When the steering wheel is
stationary the inner spool A and sleeve B are held
in the neutral position by the centring springs K. As
the unit is 'closed centre' the flow from the pump is
dead ended by the steering unit.
Note: The steer setting valve shown at X is always
in the closed position for normal steering operation.
For further details refer to Service Procedures -
Initial System Bleeding and Re-Aligning the
Road Wheels.
Component Key:
A Inner Spool
B Sleeve
D Stator
K Centring Springs
X Steer Setting Valve
43C Non-Return Valve
4 - 1
4 - 1
Circuit Description
Section H
Section H
To Next Page
Loading...
