JCB EcoMAX Engine Installation Manual
Page 14 of 64 320/A9164-1 © JCB Power Systems Ltd.
3.3 Fan Design
A pusher type cooling fan is normally fitted on the engine; Puller fans are available for some
of the IPU products however fitting a puller fan will increase the temperature around the
engine bay and aftertreatment components and could risk causing temperature limits for
such components to be exceeded. For further advice and guidance consult your JCB
EcoMAX dealer, or JCB Power Systems Applications department.
Alternator air inlet temperature at the rear of the unit must not exceed 118
0
C in maximum
ambient temperatures.
It is important that the engine installer takes care to adequately guard the flywheel and other
moving equipment. These guards should be earthed to prevent the build-up of static
electricity. The installer should ensure that it is not possible for any part of an operator’s
body to come into contact with moving parts.
To Next Page
Loading...
