JDE PRMSS-001 - 7 Cleaning; About Cleaning; Cleaning of the Cooling Box Interior; Cleaning of the Water Tank Interior; Lid

20
7. CLEANING
7.1ABOUTCLEANING
To ensure maximum hygiene and drink quality it
is recommended to check and clean a few specic
items on a daily basis.
In addion the dispenser features automac clean-
ing procedures to ensure a high hygiene standard:
• Cleaning:full cleaning procedure at least once
per week (approx. 7 minutes)
• Flushing : rinsing the p of the doser and out-
let with hot water of the when placing a new
pack (approx. 1 minutes)
• Clean-shot:a small shot of hot water to ush
the outlet 30 minutes aer the last milk drink
(approx. 6 seconds)
The steps that you have to perform are shown in
the machine display.
7.2CLEANINGOFTHECOOLINGBOXINTERIOR
It may somemes be necessary to remove the
levers as shown above to reach areas inside the
cooling box for cleaning;
1. press both sides of the lever inwards to release
the part.
2. you can now take the lever out.
Should ingredient (coee, milk) leak or get spilled
inside the cooling box: Clean the indicated areas
thoroughly.
7.3CLEANINGOFTHEWATERTANKINTERIOR/LID
(water tank versions only)
Clean the inside of the water tank periodically.
• Take out the water tank.