JDE PRMSS-001 - Page 27

27
Error    Cause        Acon
Error code (71) Flushing procedure not executed in me Please execute the ushing procedure.
Error code (73) Cleaning procedure not executed in me Please execute the cleaning procedure.
Error code (74) The water counter set in the operator mode has been exceeded Enter the operator mode and reset the counter.
Error code (97) Hot water push buon is stuck/ not released Check if the hot water buon is stuck, correct if possible.
Error code (25/81/95/ Internal error Reset the machine : Unplug the power cord for 10 seconds
/216-219) Contact your service provider if the error remains.
Error code (202) The descaling procedure was not completed Execute and/or complate the descaling procedure.
Contact your service provider if the error remains thereaer.
Error code (203) Drip tray full Empty the drip tray. Remove the driptray (1) and clean the drip tray level detecon sensor contacts (2).
Contact your service provider if the error remains.