GETTING TO KNOW YOUR INSTRUMENT PANEL 105
LaneSense Indicator Light — If Equipped
The LaneSense indicator light
illuminates solid green when both
lane markings have been detected
and the system is “armed” and ready
to provide visual and torque warnings if an
unintentional lane departure occurs
Ú page 155.
Park/Headlight On Indicator Light
This indicator light will illuminate
when the park lights or headlights are
turned on Ú page 45.
Stop/Start Active Indicator Light
This telltale will illuminate when the
Stop/Start function is in “Autostop”
mode.
Turn Signal Indicator Lights
When the left or right turn signal is
activated, the turn signal indicator
will flash independently and the
corresponding exterior turn signal
lamps will flash. Turn signals can be activated
when the multifunction lever is moved down
(left) or up (right).
NOTE:
A continuous chime will sound if the vehicle is
driven more than 1 mile (1.6 km) with either
turn signal on.
Check for an inoperative outside light bulb if
either indicator flashes at a rapid rate.
WHITE INDICATOR LIGHTS
Active Speed Limiter Ready Indicator
Light — If Equipped
This light will turn on when the Active
Speed Limiter is on, but not set.
Adaptive Cruise Control Ready Light — If
Equipped
This light will turn on when Adaptive
Cruise Control (ACC) has been turned
on, but is not set Ú page 130.
Adaptive Cruise Control Set Light — If
Equipped
This light will turn on when the vehicle
equipped with Adaptive Cruise
Control (ACC) has reached the speed
desired and the set button has been
selected Ú page 130.
Hill Descent Control Indicator Light — If
Equipped
This indicator shows when the Hill
Descent Control (HDC) feature is
turned on. The lamp will be on solid
when HDC is armed. HDC can only be
armed when the transfer case is in the 4WD
LOW position and the vehicle speed is less then
30 mph (48 km/h). If these conditions are not
met while attempting to use the HDC feature,
the HDC indicator light will flash on/off.
LaneSense Indicator Light — If Equipped
When the LaneSense system is ON,
but not armed, the LaneSense
indicator light illuminates solid white.
This occurs when only left, right, or
neither lane line has been detected. If a single
lane line is detected, the system is ready to
provide only visual warnings if an unintentional
lane departure occurs on the detected lane line
Ú page 155.
3
21_KL_OM_EN_USC_t.book Page 105
To Next Page
Loading...
