40 GETTING TO KNOW YOUR VEHICLE
NOTE:
To remove the head restraint, raise it as far
as it can go. Then, push the release button
and the adjustment button at the base of
each post while pulling the head restraint up.
To reinstall the head restraint, put the head
restraint posts into the holes and push down-
ward. Then, adjust the head restraint to the
appropriate height.
The seatback may need to be reclined in
order to fully remove the outboard head
restraints.
Outboard Head Restraint
Center Head Restraint
STEERING WHEEL
TILT/TELESCOPING STEERING COLUMN
This feature allows you to tilt the steering
column upward or downward. It also allows
you to lengthen or shorten the steering column.
The tilt/telescoping lever is located below the
steering wheel at the end of the steering
column.
Tilt/Telescoping Lever
1 — Release Button
2 — Adjustment Button
1 — Adjustment Button
2 — Release Button
WARNING!
ALL the head restraints MUST be reinstalled in
the vehicle to properly protect the occupants.
Follow the re-installation instructions above prior
to operating the vehicle or occupying a seat.
21_KL_OM_EN_USC_t.book Page 40
To Next Page
Loading...
