SERVICING AND MAINTENANCE 373
ENGINE AIR CLEANER FILTER
Refer to the Maintenance Plan in this section for
the proper maintenance intervals
Ú
page 364.
NOTE:
Be sure to follow the “Severe Duty Conditions”
maintenance interval if applicable.
Engine Air Cleaner Filter Selection
The quality of replacement filters varies
considerably. Only high quality Mopar certified
filters should be used.
Engine Air Cleaner Filter Inspection and
Replacement
Inspect engine air cleaner filter for dirt and or
debris. If you find evidence of either dirt or
debris you should change your air cleaner filter.
Engine Air Cleaner Filter Removal
1. Remove the screws from the engine air
cleaner filter cover.
Engine Air Cleaner Filter Cover
2. If equipped with a 2.0L, remove the screws
from the engine air cleaner filter cover and
disconnect the electrical sensor.
Engine Air Cleaner Filter Cover
WARNING!
The air induction system (air cleaner, hoses,
etc.) can provide a measure of protection in the
case of engine backfire. Do not remove the air
induction system (air cleaner, hoses, etc.)
unless such removal is necessary for repair or
maintenance. Make sure that no one is near
the engine compartment before starting the
vehicle with the air induction system (air
cleaner, hoses, etc.) removed. Failure to do so
can result in serious personal injury.
1 — Clean Air Hose Clamp
2 — Screws
1 — Screws
2 — Electrical Connector
3 — Clean Air Hose Clamp
8
21_KL_OM_EN_USC_t.book Page 373
To Next Page
Loading...
