GETTING TO KNOW YOUR VEHICLE 47
HIGH/LOW BEAM SWITCH
After the low beam headlights are turned on, push
the multifunction lever, located on the left side of
the steering wheel, away from you to switch the
headlights to high beam. Pulling the multifunction
lever back will turn the low beams on.
AUTOMATIC HIGH BEAM HEADLAMP
C
ONTROL — IF EQUIPPED
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automatically controlling the high
beams through the use of a camera mounted
on the windshield. This camera detects vehicle
specific light and automatically switches from
high beams to low beams until the approaching
vehicle is out of view.
NOTE:
The multifunction lever must be in the high
beam position in order to activate the Auto-
matic High Beams.
The Automatic High Beam Headlamp Control
can be turned on or off using the Uconnect
system Ú page 181.
Broken, muddy, or obstructed headlights and
taillights of vehicles in the field of view will
cause headlights to remain on longer (closer to
the vehicle). Also, dirt, film, and other obstruc-
tions on the windshield or camera lens will
cause the system to function improperly.
When set to AUTO, the system automatically
turns the headlights on or off based on
ambient light levels.
FLASH-TO-PASS
You can signal another vehicle with your
headlights by lightly pulling the multifunction
lever toward you. This will cause the high beam
headlights to turn on, and remain on, until the
lever is released.
AUTOMATIC HEADLIGHTS — IF EQUIPPED
This system automatically turns the headlights
on or off according to ambient light levels.
To turn the system on, rotate the headlight
switch to the AUTO position for automatic
headlight operation. When the system is on,
the headlight time delay feature is also on.
This means the headlights will stay on for up to
90 seconds after you place the ignition in the
OFF position. To turn the automatic system off,
move the headlight switch out of the AUTO
position.
NOTE:
The engine must be running before the head-
lights will come on in the automatic mode.
PARKING LIGHTS
Rotate the headlight switch clockwise to the
first detent for parking light and instrument
panel light operation. Rotate the headlight
switch to the second detent for headlight,
parking light and instrument panel light
operation.
NOTE:
For vehicles sold in Canada, the first headlight
switch position is the parking light and instru-
ment panel light position (instead of the OFF posi-
tion). Rotate the headlight switch clockwise to the
second detent to turn on headlight, parking light,
and instrument panel light operation.
2
21_KL_OM_EN_USC_t.book Page 47
To Next Page
Loading...
