GETTING TO KNOW YOUR VEHICLE 23
Automatic Temperature Control (ATC) — If
Equipped
The climate controls automatically adjust to
the optimal temperature and mode settings
dependent on the outside ambient temperature.
This will occur until the driver’s door is opened, or
the ignition is placed in the ON/RUN position
where the climate controls will resume their
previous settings.
Manual Temperature Control (MTC) — If
Equipped
In ambient temperatures at 40°F (4.5°C) or
below, the climate settings will default to
maximum heat, with fresh air entering the
cabin. If the front defrost timer expires, the
vehicle will enter Mix Mode.
In ambient temperatures from 40°F (4.5°C)
to 78°F (26°C), the climate settings will be
based on the last settings selected by the
driver.
In ambient temperatures at 78°F (26°C) or
above, the climate settings will default to MAX
A/C, Bi-Level Mode, and Recirculation on.
For more information on ATC, MTC, and climate
control settings, see Ú page 55.
NOTE:
These features will stay on through the duration
of Remote Start until the driver’s door is opened,
or until the ignition is placed in the ON/RUN posi-
tion. The climate control settings will change if
manually adjusted by the driver while the vehicle
is in Remote Start mode, and exit automatic over-
ride. This includes the OFF button on the climate
controls, which will turn the system off.
REMOTE START WINDSHIELD WIPER
D
E–ICER ACTIVATION — IF EQUIPPED
When Remote Start is active and the outside
ambient temperature is less than 33°F (0.6°C),
the Windshield Wiper De-Icer will be enabled.
Exiting remote start will resume previous
operation, except if the Windshield Wiper De-Icer
is active. The Windshield Wiper De-Icer timer and
operation will continue.
VEHICLE SECURITY SYSTEM — IF EQUIPPED
The Vehicle Security system monitors the vehicle
doors, hood, liftgate, and the Keyless Enter-N-Go
— Ignition for unauthorized operation. While the
Vehicle Security system is armed, interior
switches for door locks and liftgate release are
disabled. If something triggers the alarm, the
Vehicle Security system will provide the following
audible and visible signals:
The horn will pulse.
The turn signals will flash.
The vehicle security light in the instrument
cluster will flash.
TO ARM THE SYSTEM
Follow these steps to arm the Vehicle Security
system:
1. Make sure the vehicle’s ignition is placed
in the OFF position.
For vehicles equipped with Keyless Entry,
make sure the vehicle’s keyless ignition
system is OFF.
2
21_KL_OM_EN_USC_t.book Page 23
To Next Page
Loading...
