STARTING AND OPERATING 175
1. Bring the vehicle to a complete stop on
level ground, and shift the transmission to
PARK.
2. Turn the engine off.
3. Turn the ignition to the ON/RUN mode, but
do not start the engine.
4. Press and hold the brake pedal.
5. Shift the transmission into NEUTRAL.
6. Using a ballpoint pen or similar object, push
and hold the recessed NEUTRAL (N) button
(located by the selector switch) for four
seconds. The light behind the N symbol will
blink, indicating shift in progress. The light
will stop blinking (stay on solid) when the
shift to NEUTRAL (N) is complete.
Neutral Button
7. After the shift is completed and the
NEUTRAL (N) light stays on, release the
NEUTRAL (N) button.
8. Start the engine.
9. Release the parking brake.
10. Shift the transmission into REVERSE.
11. Release the brake pedal for five seconds
and ensure that there is no vehicle
movement.
12. Shift the transmission to NEUTRAL.
13. Apply the parking brake.
14. Shift the transmission into PARK, turn the
engine off, and remove the key fob.
15. Attach the vehicle to the tow vehicle using a
suitable tow bar.
16. Turn the ignition to the ON/RUN mode, but
do not start the engine.
17. Press and hold the brake pedal.
18. Release the parking brake.
19. Turn the ignition OFF, remove the key fob,
and release the brake pedal.
NOTE:
When towing this vehicle behind another
vehicle, the parking brake must be released.
Steps 1 through 5 are requirements that must
be met before pushing the NEUTRAL (N)
button, and must continue to be met until the
shift has been completed. If any of these
requirements are not met before pushing the
NEUTRAL (N) button or are no longer met
during the shift, then the NEUTRAL (N) indi-
cator light will flash continuously until all
requirements are met or until the NEUTRAL (N)
button is released.
4
21_KL_OM_EN_USC_t.book Page 175
To Next Page
Loading...
