16 GETTING TO KNOW YOUR VEHICLE
To Lock/Unlock The Doors And Liftgate
Push the interior door unlock button on the door
panel.
NOTE:
If the vehicle is unlocked using the interior door
panel, and no door is opened within 60 seconds,
the vehicle will re-lock and if equipped, the secu-
rity system will arm. You can change the current
setting within the Uconnect system.
Ú
page 181.
Push and release the unlock button on the key
fob once to unlock the driver’s door, or twice
within five seconds to unlock all the doors and
the liftgate. To lock all the doors and the liftgate,
push the lock button once.
When the doors are unlocked, the turn signals
will flash and the illuminated entry system will
be activated. When the doors are locked, the
turn signals will flash and the horn will chirp.
This setting can be adjusted in the Uconnect
system Ú page 181.
Replacing The Battery In The Key Fob
The replacement battery is one CR2032 battery.
NOTE:
Customers are recommended to use a
battery obtained from Mopar. Aftermarket
coin battery dimensions may not meet the
original OEM coin battery dimensions.
Perchlorate Material — special handling
may apply. See
www.dtsc.ca.gov/hazard-
ouswaste/perchlorate
for further information.
Do not touch the battery terminals that are
on the back housing or the printed circuit
board.
1. Remove the emergency key by sliding the
mechanical latch on the back of the key
fob sideways with your thumb and then pull
the key out with your other hand.
Emergency Key Removal
Emergency Key Removal
2. Separating key fob halves requires screw
removal (if equipped), and gently prying the
two halves of the key fob apart. Make sure
not to damage the seal during removal.
21_KL_OM_EN_USC_t.book Page 16
To Next Page
Loading...
