SAFETY 291
3. Route the shoulder belt through the seat
belt guide loop on the top of the seatback
near the inboard side of the left head
restraint.
Inserting Mini-Latch Plate Into Mini-Buckle
4. When the seat belt is long enough to fit,
insert the mini-latch plate into the
mini-buckle until you hear a “click.”
Mini-Latch Plate Buckled
5. Sit back in seat. Slide the regular latch plate
up the webbing as far as necessary to allow
the seat belt to go around your lap.
6. When the seat belt is long enough to fit,
insert the latch plate into the buckle until
you hear a “click.”
7. Position the lap belt so that it is snug and lies
low across your hips, below your abdomen.
To remove slack in the lap belt portion, pull
up on the shoulder belt. To loosen the lap belt
if it is too tight, pull on the lap belt. A snug
seat belt reduces the risk of sliding under the
seat belt in a collision.
8. Position the shoulder belt on your chest so
that it is comfortable and not resting on your
neck. The retractor will withdraw any slack
in the seat belt.
Rear Center Seat Belt Buckled
9. To release the seat belt, push the red button
on the buckle.
6
21_KL_OM_EN_USC_t.book Page 291
To Next Page
Loading...
