Page 16 of 47
2 – SAFETY INFORMATION
_____________________________________________________________________________________________
In order to avoid unintended start-up, the emergency state remains active until the machine is put
into service.
To put the machine back into service:
Note: Before putting the machine back into service, remove the cause of danger.
→ Find out the push button used to activate the emergency state;
→ Rotate the mushroom-shaped button in the direction indicated by the arrow s printed on it;
→ The push-button is now back in service and the machine is ready to w ork.
→ Push the turn on engine button to start-up the machine
2.6 Daily check
Daily checks to be performed before starting the machine::
o Check hydraulic oil level
o Verify there is no visible oil leakage
o Check safety micro-sw itch. Remove possible mud, grease, etc. residues without using
metal tools.
o Test safety systems
o Carpentry condition visual check
o Verify safety labels are present and readable
o Make sure the w orking area is ventilated as batteries produce explosive gases
o Check greasing of the machine
2.7 Features of the working area
To avoid unpleasant troubles or even accidents working areas have to meet specific requirements
such as:
o Ground slope smaller than 5 %;
o The w heel must lay on solid ground, w ithout manhole, cover, etc.
o Check pow er supply availability at the voltage required by the machine and in
o conformity w ith the rules in force.
In case the machine has to work on upper floors, verify their maximum
loading capacity according to what indicated in paragraph ‘Technical
Specifications’.
CAUTION!!!
Don't work on floors without having verified their loading capacity. The
manufacturer declines any responsibility arising from damage or
collapse.
https://cranemanuals.com
To Next Page
Loading...
