Page 9 of 47
1-PREFACE
_____________________________________________________________________________________________
In order to increase the rope lifting
capacity it is necessary to assemble
the hook device as indicated in the
picture and to set the machine by
means of the sw itchboard. Every
machine is equipped w ith a chart, as
the one indicated in the picture, w hich
indicates the w inch lifting capacity
depending on the configuration
chosen.
1.3 Original Seals
The manufacturer has placed lead sealings on machine components to assure w orking under safe
conditions.
ORIGINAL SEAL REMOVAL WILL CAUSE MACHINE UNSAFE WORKING.
THE MANUFACTURER DECLINES ANY RESPONSIBILITY ARISING
FROM UNSAFE USE OF MACHINES.
1.4 Operator Training
Technical training is required to the operator in order to correctly operate this machine. ORMET
SPA qualified personnel is available to train your personnel in many European countries. Contact
your dealer for more information. If you can not find a dealer in your country please call OREMT
SPA
1.5 Intended use
The machine has been designed to handle loads by means of a lifting hook, a w inch or an
accessory jib: loads must not exceed the load diagram printed or labelled on the crane. The
machine is designed for internal use only.
¾ All uses not expressly declared in this manual are to be considered not intended, especially
any use different from those described in this manual.
CAUTION!
Inside the European Community it’s forbidden use the machine to lift
people
MAX 1323 lbs MAX 2646 lbs MAX 3969 lbs
https://cranemanuals.com
To Next Page
Loading...
