Pagina 39 di 47
8– STANDAR OPERATOR
MAINTENANCE
__________________________
_________________________________________________________________
Battery
• Alw ays wear individual protective clothing such as safety glasses, gloves, etc. when
performing battery maintenance.
• Never add acid to the battery.
• Do not expose to extreme heat or open flame.
• Make sure electrolyte covers are close
• Keep the battery clean and dry.
8.3 How to increase the battery lifetime
Charging
• Re-charge battery after each usage.
• Verify electrolyte level is over the plates.
• Tighten vent caps before charging;
• Do not interrupt charge cycle;
• Never charge a frozen battery.
• Perform re-charging in ventilated areas only.
Topping-up
• Add w ater only after have completely re-charged the battery;
• Never let the electrolyte level falls below the plates;
• Use distilled w ater or water with low mineral content.
Cleaning
• Nothing has to fall inside the battery.
• Clean only w ith w ater, then dry.
• Protect cables w ith anti-rust products.
Storing
• Completely charge the battery before storing.
• Store batteries in a cool, dry location.
• Avoid direct exposure to heat sources such as radiators or heaters
• While storing, charge batteries every six weeks.
8.4 General warnings for maintenance activity
The machine must be parked on a level surface.
Perform maintenance w hen the machine is cold.
Rest the machine on some blocks, it cannot be kept lifted.
Rest all disassembled components on solid surfaces and place them so that they cannot
fall in case hydraulic pressure should fall. Tutte le parti rimosse devono essere appoggiate
su superfici solide e posizionate in modo che non cadano se la pressione idraulica decade
All lifting devices must comply w ith the rules in force.
If possible, do not climb on the machine but use suitable lifting platforms.
Wear individual protective clothing (D.P.I.) such as gloves, glasses, etc.).
https://cranemanuals.com
To Next Page
Loading...