Johnson Controls TIWM006B21S - Setback Operation

18
P5417053-rev.1
 $XWRPDWLF+HDWLQJ&RROLQJ2SHUDWLRQ
,QFDVHGXDOVHWSRLQWLVVHOHFWHGLQDXWRPDWLFKHDWLQJFRROLQJ
operation, during auto mode both cooling setpoint and heating
setpoint can be selected.
%\GHIDXOWWHPSHUDWXUHZKHQWKHKHDWLQJFRROLQJPRGHFKDQJHV
are as follows.
Cooling mode changes to heating mode when the indoor
temperature is heating setpoint -2
o
)
o
C).
Heating mode changes to cooling mode when the indoor
temperature is cooling setpoint +2
o
)
o
C).
If the temperature for changing modes requires to be changed,
contact your distributor or contractor for details.
NOTE:
In case of Celsius Indication.
NOTE:
,QFDVHRI)DKUHQKHLW,QGLFDWLRQ
5.1.8 Setback Operation
If the setback operation is enabled and the card key is removed,
the louver starts to open in approximately 5 seconds, the setpoint is
adjusted for setback, and the fan operates at “Low” speed.
During this time, “Setback” is displayed on the LCD.
By default,
Cooling: Setpoint +4
o
)
o
C)
Heating: Setpoint -4
o
)
o
C)
If the adjustment for setback operation must be changed, contact
your distributor or contractor for details.
$QDXWRPDWLFKHDWLQJFRROLQJRSHUDWLRQDQGVHWEDFNRSHUDWLRQUHTXLUHVH[WUDVHWWLQJV
Contact your distributor or contractor for details.